Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual / Vehicle Interior / Seat / Rear Seatback Heater (for Captain Seat Type) / Inspection

INSPECTION

PROCEDURE

1. INSPECT SEAT HEATER ASSEMBLY (for LH Side)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Seat heater temperature 20 °C (68 °F)

3.98 to 4.78 Ω

If the result is not as specified, replace the seat heater assembly (for LH side).

*a

Component without harness connected

(Seat Heater Assembly (for LH Side))

2. INSPECT SEAT HEATER ASSEMBLY (for RH Side)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Seat heater temperature 20 °C (68 °F)

3.98 to 4.78 Ω

If the result is not as specified, replace the seat heater assembly (for RH side).

*a

Component without harness connected

(Seat Heater Assembly (for RH Side))
    Components
    COMPONENTS ILLUSTRATION *1 CUP HOLDER ASSEMBLY *2 NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH *3 NO. 1 SEAT ARMREST CAP *4 REAR SEAT ARMREST ASSEMBLY LH *5 REAR SEAT COVER CAP ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Automatic Transaxle System: Transmission Fluid Temperature Sensor "A" Circuit Range/Performance (P071000)
    DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Propeller Shaft Assembly: Installation
    INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (a) Remove SST from the transfer assembly. (b) Insert the propeller with center bearing shaft assembly into the transfer assembly. NOTICE: Be careful not to damage the transfer extension hous ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.015