ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear center seat outer belt assembly.
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the rear center seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear center seat outer belt assembly with a new one.
2. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the rear center seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear center seat outer belt assembly with a new one.
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof Housing (for Panoramic Moon Roof): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR SLIDING ROOF GARNISH (a) Engage the 3 guides and 4 claws to install the rear sliding roof garnish to the sliding roof housing panel. 2. INSTALL NO. 1 SLIDING ROOF SIDE GARNISH LH (a) Clean the sliding roof housing panel. (1) Using a heat light, hea ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Ground (P011011)
DESCRIPTION The intake air temperature sensor, mounted on the mass air flow meter sub-assembly, monitors the intake air temperature. The intake air temperature sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the intake air temperat ...