INSPECTION
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
| (a) After installing the rear center seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) Move the seatback of the rear No. 1 seat assembly RH to the upright position. Check that the seatbelt can be pulled from the retractor when the angle of the seatback of the rear No. 1 seat assembly RH is between 12° forward and 28° rearward of the standard position. Check that the seatbelt locks when the angle of the seatback of the rear No. 1 seat assembly RH is 27° or more forward or 43° or more rearward of the standard position. HINT:
If the result is not as specified, replace the rear center seat outer belt assembly. |
|
On-vehicle Inspection
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Fuel Rail Pressure Sensor "A" Circuit Short to Battery or Open (P019015)
DESCRIPTION Refer to DTC P019011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P019015 Fuel Rail Pressure Sensor "A" Circuit Short to Battery or Open The fuel pressure sensor (for high pressure side) output voltage is higher than 4.9 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...