COMPONENTS
ILLUSTRATION
| *1 | NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH | *2 | REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER |
| *3 | REAR SEAT COVER CAP RH | *4 | REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH |
| *5 | SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD | - | - |
ILLUSTRATION
| *1 | REAR CENTER SEAT OUTER BELT ASSEMBLY | *2 | REAR SEAT SHOULDER BELT COVER |
| *3 | REAR SEAT UPPER RECLINING COVER RH | *4 | REAR SEATBACK BOARD CARPET ASSEMBLY RH |
| *5 | REAR SEATBACK COVER RH | *6 | REAR SEATBACK EDGE PROTECTOR |
| *7 | RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH | *8 | SEAT BELT ANCHOR COVER CAP |
| *9 | SEPARATE TYPE REAR SEATBACK COVER WITH PAD | *10 | REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | | N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
On-vehicle InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fog Light Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Memory Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL SEAT MEMORY SWITCH LH (a) Engage the 4 claws to install the seat memory switch LH to the front door trim board sub-assembly LH. 2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH Click here 3. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION Click here ...