INSPECTION
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
| (a) Before installing the rear center seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is between 27° and 37°, check that the belt can be pulled from the retractor. When the inclination of the retractor is less 27° or more than 37°, check that the belt locks. If the result is not as specified, replace the rear center seat outer belt assembly. |
|
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Seat Switch (for Rear No. 2 Seat): Inspection
INSPECTION PROCEDURE 1. INSPECT FOLD SEAT SWITCH ASSEMBLY (a) Inspect fold seat switch assembly (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Ground Tester Connection Condition Specified Condition 8 - 7 Fold switch (RH) pushed Below ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Heater Switch (for Front Side): Removal
REMOVAL PROCEDURE 1. REMOVE REAR CONSOLE UPPER PANEL Click here 2. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Click here 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Click here 4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Click here 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT ...