Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SEAT INNER BELT ASSEMBLY LH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Rear No. 1 LH seat belt unfastened

Below 1 Ω

Rear No. 1 LH seat belt fastened

10 kΩ or higher

If the result is not as specified, replace the rear seat inner belt assembly LH.

*a

Component without harness connected

(Rear Seat Inner Belt Assembly LH)

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not allow the a ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: System Description
    SYSTEM DESCRIPTION UNLOCK OPERATION CONDITIONS FOR STEERING LOCK (a) When the following condition is met, the unlock operation is performed. The engine switch is on (ACC) or on (IG). HINT: When the engine switch is turned on (ACC) or on (IG) and the key and certification ECU (smart key ECU assemb ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ambient Light(for Rear Door): Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (REAR DOOR AMBIENT ILLUMINATION LIGHT LH) (a) Apply battery voltage to the connector and check that the rear door ambient illumination light LH comes on. OK: Measurement Condition Condition Specified Condition Batter ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0099