INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH
(a) Install the rear seat inner belt assembly LH with the bolt.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
| Protruding Part |
NOTICE:
Do not allow the anchor part of the rear seat inner belt assembly LH to overlap the protruding parts of the rear seat cushion frame sub-assembly.
(b) Engage 2 clamps.
(c) Connect the connector.
2. INSTALL REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER
Click here
3. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Click here
4. INSTALL REAR SEAT INNER RECLINING COVER LH
Click here
5. INSTALL CUP HOLDER ASSEMBLY
Click here
6. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
Click here
7. INSTALL NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH
Click here
8. INSTALL REAR SEAT COVER CAP LH
Click here
9. INSTALL REAR NO. 1 SEAT ASSEMBLY LH
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Combination Meter Mirror ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Combination Meter Mirror ECU Communication Stop Mode Either condition is met:
"Head Up Display" is not displayed on the CAN Bus Check screen of the Techstream.
Click here
Communication system DTCs (DTCs that start with U) that co ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Back Door Closer Switch Malfunction (B2251)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, position switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these signals, the latch position of the back door lock assembly is determined. DTC No. Detec ...