DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1551 | HD Radio Tuner Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
| Radio receiver assembly |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15B4 | CD Changer Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15B5 | DVD Changer Malfunction | When any of the following conditions is met:
| Radio receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio receiver assembly |
| B15F9 | UART Communication Malfunction(for A/C) | When either of the following conditions is met:
| Radio receiver assembly |
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
Extension Module Disconnected 2 (B1543)
Extension Module Malfunction 2 (B1556)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in Side Squib (RH) Circuit (B1820-B1823)
DESCRIPTION The front side squib RH circuit consists of the airbag sensor assembly and front seat airbag assembly RH. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front side squib RH ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Gear: Installation
INSTALLATION PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned. HINT: After adjusting the toe-in, tighten the lock nut. *a Matchmark 2. INSTALL TIE ROD ASSEMBLY RH HINT: ...