ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear No. 2 seat outer belt assembly.
PROCEDURE
1. INSPECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Visually check for defects with the rear No. 2 seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 2 seat outer belt assembly with a new one.
2. INSPECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Visually check for defects with the rear No. 2 seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 2 seat outer belt assembly with a new one.
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Starter: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY (a) Remove the nut and disconnect the field coil lead wire from terminal C. (b) While holding the magnet starter switch assembly to the starter drive housing assembly, remove the 2 nuts. (c) Remove the magne ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Hydraulic Test
HYDRAULIC TEST PERFORM HYDRAULIC TEST (a) Measure the line pressure. CAUTION: A line pressure test should always be carried out with at least 2 people. One person should observe the condition of wheels and wheel chocks while the other is performing the test. NOTICE:
Perform this test with the ATF ...