INSTALLATION
PROCEDURE
1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH
| (a) Install the rear seat inner belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not allow the anchor part of the rear seat inner belt assembly LH to overlap the protruding parts of the cushion frame. |
|
(b) Engage each clamp.
2. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Click here
3. CONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Click here
4. INSTALL NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
Click here
5. INSTALL REAR SEAT COVER CAP LH (for Manual Seat)
Click here
6. INSTALL POWER SEAT SWITCH ASSEMBLY (for Power Seat)
Click here
7. INSTALL REAR CENTER SEAT INNER BELT ASSEMBLY
Click here
8. INSTALL REAR SEAT ASSEMBLY LH
Click here
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Variation Code not Written (B2451)
DESCRIPTION The No. 1 headlight ECU sub-assembly LH stores this DTC if the vehicle specifications have not been stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2451 Variation Code not Written
The engine switch is on (IG).
Vehicle speci ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Transfer Case Front Oil Seal (for Lh Side): Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal removal/installation are shown below. Necessary Procedure After Parts Removed ...