INSTALLATION
PROCEDURE
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
(a) Install the rear seat 3 point type belt assembly RH with the bolt.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
(b) Connect the connector.
(c) Engage each clamp.
2. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Click here
3. CONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Click here
4. INSTALL NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)
Click here
5. INSTALL REAR SEAT COVER CAP RH (for Manual Seat)
Click here
6. INSTALL POWER SEAT SWITCH ASSEMBLY (for Power Seat)
Click here
7. INSTALL REAR SEAT ASSEMBLY RH
Click here
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Sfi System: Cold Start Ignition Timing Performance (P050B00)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine is ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Propeller Shaft Assembly: Components
COMPONENTS ILLUSTRATION *A for Front Side *B for Rear Side *C for TMC Made *D for TMMC Made *E for Type A *F for Type B *1 FRONT CENTER FLOOR COVER *2 FRONT FLOOR COVER LH *3 NO. 2 ENGINE UNDER COVER *4 PROPELLER SHAFT GUARD *5 WIRING HARNESS C ...