INSPECTION
PROCEDURE
1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY
| (a) Before installing the rear No. 1 seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks. If the result is not as specified, replace the rear No. 1 seat outer belt assembly. |
|
Removal
DisposalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Multi-axis Acceleration Sensor Module "A" Signal Compare Failure (C052062)
DESCRIPTION The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the acceleration sensor (yaw rate and acceleration sensor) via CAN communication. DTC No. Detection Item ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Airbag Sensor (w/ Rear No. 2 Seat): On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the rear airbag sensors. PROCEDURE 1. INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here 2. INSPECT REAR ...