DESCRIPTION
This procedure is for troubleshooting when the ABS warning light remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the ABS warning light in the combination meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
| 1. | INSPECT COMBINATION METER ASSEMBLY |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Enter the following menus: Body Electrical /Combination Meter / Active Test.
(d) Perform the Active Test of the combination meter assembly using the Techstream.
Body Electrical > Combination Meter > Active Test| Tester Display |
|---|
| Indicat. Lamp ABS |
(e) Check the combination meter assembly.
OK:
The ABS warning light turns on or off in accordance with the Techstream operation.
| OK | | REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
Control Module Communication Bus "B" Off Bus Off (U007488,U010087,U010187,U012587,U012687,U015187)
ABS Warning Light does not Come ONLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Assembly (for 60/40 Split Seat Type Lh Side): Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. PROCEDURE 1. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY LH (a) Temporarily install the rear seatback frame sub-assembly LH to the No. 1 seat cushion frame sub-assembly LH as shown i ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Roof Headlining (w/ Rear No. 2 Seat): Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY Click here 2. REMOVE WASHER HOSE ASSEMBLY (a) Remove the washer hose assembly. *A for Standard Roof *B for Sliding Roof 3. REMOVE VANITY LIGHT ASSEMBLY Click here 4. REMOVE TELEPHONE MICROPHONE ASSEMBLY Click here 5 ...