DESCRIPTION
The skid control ECU (brake actuator assembly) controls the ABS warning light in the combination meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Click here
PROCEDURE
| 1. | INSPECT COMBINATION METER ASSEMBLY |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Enter the following menus: Body Electrical /Combination Meter / Active Test.
(d) Perform the Active Test of the combination meter assembly using the Techstream.
Body Electrical > Combination Meter > Active Test| Tester Display |
|---|
| Indicat. Lamp ABS |
(e) Check the combination meter assembly.
OK:
The ABS warning light turns on or off in accordance with the Techstream operation.
| OK | | REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
ABS Warning Light Remains ON
Brake Warning Light does not Come ONLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Knock Sensor: Installation
INSTALLATION PROCEDURE 1. INSTALL KNOCK CONTROL SENSOR HINT: Perform "Inspection After Repair" after replacing a knock control sensor. Click here (a) Temporarily install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation p ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors have been disconnected, initialize the power back door system. Click here HINT:
Use the table below to help determine the cause of problem symptoms. If multip ...