DESCRIPTION
The skid control ECU (brake actuator assembly) controls the brake warning light in the combination meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Click here
PROCEDURE
| 1. | INSPECT COMBINATION METER ASSEMBLY |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Enter the following menus: Body Electrical /Combination Meter / Active Test.
(d) Perform the Active Test of the combination meter assembly using the Techstream.
Body Electrical > Combination Meter > Active Test| Tester Display |
|---|
| Indicat. Lamp Brake |
(e) Check the combination meter assembly.
OK:
The brake warning light turns on or off in accordance with the Techstream operation.
| OK | | REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
ABS Warning Light does not Come ON
Brake Warning Light Remains ONLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 2 Seat Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. PROCEDURE 1. INSTALL REAR SEAT INNER BELT COVER LH (a) Engage the claw. (b) Install the rear seat inner belt cover LH with the clip. 2. INSTALL REAR ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Radio Antenna Cord (w/o Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 4 ANTENNA CORD SUB-ASSEMBLY (a) Engage the 4 clamps to install the No. 4 antenna cord sub-assembly. (b) Connect the connector. 2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY Click here 3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Click here 4. INSTALL D ...