ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT RADIO SETTING CONDENSER
(a) With the radio setting condenser installed, check that there is no looseness or other abnormalities.
| (b) Measure the resistance of the radio setting condenser according to the value(s) in the table below. Standard Resistance:
|
|
(c) Remove the bolt.
(d) Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.
| (e) Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below. Standard Resistance:
Standard Voltage:
|
|
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fuel Pump (for Tmmc Made): Components
COMPONENTS ILLUSTRATION *1 REAR DOOR SCUFF PLATE LH *2 UPPER QUARTER TRIM PAD LH *3 REAR SEAT SIDE GARNISH LH - - ILLUSTRATION *1 REAR DOOR SCUFF PLATE RH *2 UPPER QUARTER TRIM PAD RH *3 REAR SEAT SIDE GARNISH RH - - ILLUSTRATION *1 FRONT FLOOR CAR ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cylinder Head Gasket: Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CYLINDER HEAD GASKET (a) Place a new No. 2 cylinder head gasket on the cylinder block sub-assembly as shown in the illustration. *a Lot No. Front of Engine NOTICE:
Remove any oil from the contact surfaces.
Make sure to install the No. 2 cy ...