ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the curtain shield airbag assemblies.
PROCEDURE
1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the curtain shield airbag assemblies installed to the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace each pillar garnish or the roof headlining assembly with a new one.
2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the curtain shield airbag assemblies removed from the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the curtain shield airbag assembly with a new one.
Installation
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ultrasonic Sensor (for Front): Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Crankshaft Oil Seal: Components
COMPONENTS ILLUSTRATION *1 REAR ENGINE OIL SEAL *2 NO. 1 CRANKSHAFT POSITION SENSOR PLATE *3 DRIVE PLATE AND RING GEAR SUB-ASSEMBLY *4 REAR DRIVE PLATE SPACER N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part MP grease Adhesive 1324 ★ Pr ...