Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Precaution

1. An object is placed on the passenger seat and the system judges that an adult is seated. As the occupant classification system detects and classifies occupants based on weight, the system may detect an object placed on the seat cushion as an adult passenger depending on its weight.
2. Pressure is applied to the passenger seat and the system judges that an adult is seated. As the occupant classification system detects and classifies occupants based on weight, the system may detect an adult passenger if pressure is applied to the seat cushion by hands, etc.
3. Illumination of the passenger airbag ON/OFF indicator does not change immediately after a passenger is seated or leaves the vehicle. To prevent the classification judgment from changing when a passenger changes their seating posture, a certain amount of time is required to detect and classify an occupant when the calculated weight changes. Therefore, there will be a time lag between when a passenger is seated or leaves the vehicle and when the system detects the occupant.

1. The occupant detection ECU is replaced.

   HINT:

   As the zero point is not automatically stored in a new occupant detection ECU, it is necessary to perform zero point calibration after replacing the occupant detection ECU.

2. Accessories (seatback tray, seat cover, etc.) are installed.

   HINT:

   As the weight of accessories will be added to the weight of the occupant, the system will not be able to perform classification accurately.

3. The front passenger seat is removed from the vehicle.

   HINT:

   As the seat frame will warp slightly when the bolts that are used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to perform classification accurately.

4. Any of the bolts that are used to install the front passenger seat are removed and reinstalled.

   HINT:

   As the seat frame will warp slightly when the bolts that are used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to perform classification accurately.

5. The passenger airbag ON/OFF indicator ("ON") illuminates when the front passenger seat is not occupied.

   HINT:

   If any load or pressure is applied to the occupant classification sensors, the system will not be able to perform classification accurately.

6. An occupant classification sensor collision detection DTC is output due to an accident or a collision.

   HINT:

   If the seat frame or vehicle floor has become deformed and additional pressure is applied to the occupant classification sensor, the system will not be able to perform classification accurately.

Occupant Classification System

...

Parts Location

PARTS LOCATION ILLUSTRATION *1 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - ECU-IG1 NO. 8 FUSE - - ILLUSTRATION *1 AIRBAG SENSOR ASSEMBLY *2 OCCUPANT DETECTION ECU ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Drive Shaft Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering Ecu: Installation
INSTALLATION PROCEDURE 1. INSTALL POWER STEERING ECU ASSEMBLY NOTICE: Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts. If the power steering ECU assembly is subjected to an impact, replace it with a new one. Do not pull the wire harness of the power ...