INSPECTION
PROCEDURE
1. INSPECT COMBINATION SWITCH ASSEMBLY
(a) Inspect the NORMAL or NORMAL CUSTOMIZE mode switch:
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the combination switch assembly. |
|
(b) Inspect the SPORT or SPORT S/S+ mode switch:
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the combination switch assembly. |
|
(c) Inspect the illumination:
| (1) Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates. Standard:
If the result is not as specified, replace the combination switch assembly. |
|
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Telephone And Gps Antenna (for Roof Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna assembly removal/installation are shown below. Necessary Procedures After Par ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Operating the lights and
wipers: Automatic High Beam
The Automatic High Beam uses a camera sensor located behind the upper
portion of the windshield to assess the brightness of the lights of vehicles
ahead, streetlights, etc., and automatically turns the high beams on or off as
necessary.
WARNING
■ Limitations of the Automatic High Beam
Do not ...