Components
COMPONENTS
ILLUSTRATION
| *1 | COOL AIR INTAKE DUCT SEAL | *2 | ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) |
| *3 | HOOD LOCK RELEASE LEVER PROTECTOR | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | | MP grease |
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the engine hood courtesy switch (hood lock assembly). |
|
Electrical Key Oscillator(for Rear Floor)
Id Code BoxLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Oil Control Solenoid (for Bank 1): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during camshaft timing oil control solenoid assembly bolt removal/installation are shown below. Necessary Proce ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Starter: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY (a) Remove the nut and disconnect the field coil lead wire from terminal C. (b) While holding the magnet starter switch assembly to the starter drive housing assembly, remove the 2 nuts. (c) Remove the magne ...