Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Lane Control System

Intelligent Clearance Sonar System

Parking Assist Monitor System

Panoramic View Monitor System

Power Door Lock Control System

Pre-collision System

Power Back Door System (w/ Outside Door Control Switch)

Lighting System (w/ Automatic Headlight Beam Level Control System)

PRECAUTIONS WHEN USING TECHSTREAM

(a) When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

PRECAUTION FOR REGISTRATION

(a) If replacing any of the following parts, refer to Registration.

(1) Certification ECU (smart key ECU assembly)

(2) ID code box (immobiliser code ECU)

(3) Steering lock ECU (steering lock actuator or upper bracket assembly)

(4) Electrical key transmitter sub-assembly

(5) ECM

(6) Main body ECU (multiplex network body ECU)

PRECAUTIONS FOR BATTERY

(a) The entry unlock function may not operate immediately after the cables are reconnected to the battery. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock or mechanical key operation.

(b) When the battery is discharged, if the battery of another vehicle is used to jump start the engine, move the shift lever to P and open and close the driver door with the engine switch off before starting the engine.

(c) After the battery is removed and reinstalled, be sure to wait at least 10 seconds before the next engine start. The engine may not start immediately after the battery is reinstalled.

HINT:

  • After disconnecting and reconnecting a cable to the battery, the engine may not start on the first attempt. If this occurs, turn the engine switch off. The engine will start normally from the second time onward.
  • When a cable to the battery is disconnected and reconnected, the power source mode returns to the mode it was in before the cable was disconnected.
    Parts Location
    PARTS LOCATION ILLUSTRATION *1 ECM - - ILLUSTRATION *A for Lexus Enform Remote Compatible Type - - *1 ENGINE SWITCH *2 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) * ...

    System Description
    SYSTEM DESCRIPTION IMMOBILISER SYSTEM DESCRIPTION (a) The immobiliser system determines whether or not to enable starting of the SFI system based on a comparison of the key ID code and the code regist ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: PIG Power Supply Voltage (C1552,C1554)
    DESCRIPTION If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU. DTC No. Detection Item DTC Detection Conditi ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 2 claws and 2 pins to install the steering pad switch assembly. (b) Install the 2 screws. Torque: 2.4 N·m {24 kgf·cm, 21 in·lbf} (c) Connect the steering pad switch connector to the spiral cable with sensor sub-assembl ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.012