Head restraints are provided for all seats.
Front seats
Vertical adjustment

Horizontal adjustment (if equipped)
The position of the head restraint can be adjusted forward in 4 stages.
If the head restraint is pulled forward from the foremost position, it will return to the rearmost position.

Second-row seats

Third-row seats (RX450hL)

■ Removing the head restraints
Front and second-row seats
Pull the head restraint up while pressing the lock release button.
If the head restraint touches the ceiling, making the removal difficult, change the seat height or angle.

Third-row seats
Pull the head restraint up while pressing the lock release button.
If the head restraint touches the ceiling, making the removal difficult, change the seat angle.

■ Installing the head restraints
Front and second-row seats
Align the head restraint with the installation holes and push it down to the lock position.
Press and hold the lock release button when lowering the head restraint.

Third-row seats
Align the head restraint with the installation holes and push it down to the lock position.
Press and hold the lock release button when lowering the head restraint.

■ Adjusting the height of the head restraints Make sure that the head restraints are adjusted so that the center of the head restraint is closest to the top of your ears.

■ Adjusting the second-row center and third-row seat head restraints Always raise the head restraint one level from the stowed position when using.
WARNING
■ Head restraint precautions Observe the following precautions regarding the head restraints.
Failure to do so may result in death or serious injury.
Driving position memoryLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Brake: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. PRECAUTION Click here 2. PERFORM REAR BRAKE PAD REPLACEMENT MODE Click here 3. REMOVE REAR WHEEL Click here 4. DRAIN BRAKE FLUID NOTICE: ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Heater Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) (a) Measure the voltage according to the value (s) in the table below. Standard Voltage: Tester Connection (Positive (+) Tester Probe - Negative (-) Tester Probe) Switch Condition Specified Con ...