Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Does not Recognize Voice Commands Performed to Contact Support Center

HINT:

• When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
• If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
• The system cannot recognize voice commands when multiple people are speaking simultaneously.
• If the speaking speed is too fast or too slow, the recognition rate may decrease.
• The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

Confirm Vehicle Headunit Functionality

PROCEDURE 1. CHECK CUSTOMER'S CELLULAR PHONE COMPATIBILITY (a) Check if the cellular phone is compatible (Refer to http://www.lexus.com/MobileLink/). Result Proceed to Cellular phone ...

DCM Data Signal Circuit between Navigation ECU and DCM

DESCRIPTION This circuit is used to send and receive signals between the DCM (Telematics Transceiver), radio receiver assembly and navigation ECU. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Oil Control Solenoid (for Bank 1): Inspection
INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY HINT: Use the same procedure for the intake side and exhaust side. (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Conditio ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Door Belt Moulding: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY Install in this Direction (a) Engage the 8 claws as shown in the illustration to install ...