Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Vehicle Control History

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System / Vehicle Control History

VEHICLE CONTROL HISTORY

NOTICE:

Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.

CHECK VEHICLE CONTROL HISTORY

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

Click here CELLULAR COMMUNICATION > SAFETY CONNECT SYSTEM > PRECAUTION

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).

Body Electrical > Telematics > Utility

Tester Display

Vehicle Control History (RoB)
Vehicle Control History Item

Code

Tester Display

Description

Diagnostic Note

X2210

Life Cycle of DCM Backup Battery

When the system detects that the mobilephone battery has reached the end of its lifespan.
  • The manual (SOS) switch red indicator illuminates
  • Replace mobilephone battery

NOTICE:

  • After replacing the mobilephone battery, perform initialization.

  • After performing work, perform "CLEAR VEHICLE CONTROL HISTORY" to turn off the manual (SOS) switch red indicator.

X2211

Low DCM Backup Battery Charge

When the mobilephone battery charge is low.

-

X2601

Software Inconsistency with ENG/HV Control Module

The VIN number received via CAN communication does not match that stored in the DCM (telematics transceiver).
  • The manual (SOS) switch red indicator illuminates
  • Perform VIN Synchronization

X2213

Emergency Call Switch Stuck On

The manual (SOS) switch is on for 5 minutes or more
  • The manual (SOS) switch red indicator illuminates.
  • Replace roof console box assembly

X2214

Communication Blackout from Power Distribution Controller ECU

Lost Communication with ECM

Check CAN Communication System

X2212

Diagnostics Communication Flow Failure

Diagnostics communication flow failure(ID, Mode/SID difference).

-

X2215

Non Approval of the Reprograming

User did not approve software update.

-

X2216

Failure of the Reprogramming

Software writing failed.

-

X2217

Inconsistent Startup Software

Software writing succeeded, but started software does not match package.

-

CLEAR VEHICLE CONTROL HISTORY

NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB) (Clear).

Body Electrical > Telematics > Utility

Tester Display

Vehicle Control History (RoB)

(e) According to the display on the Techstream, clear the Vehicle Control History (RoB).

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa ...

    Telephone Sub Antenna Circuit Short to Ground (B153711,B153713)
    DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone and GPS antenna (for Front Side). DTC No. Detection Item DTC Detection Condition Trouble Area B153711 Teleph ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL SHIFT SOLENOID VALVE SLT (a) Coat the shift solenoid valve SLT with ATF and install it to the transmission valve body assembly. (b) Install the straight pin. 2. INSTALL SHIFT SOLENOID VALVE SL5 (a) Coat the shift solenoid valve SL5 with ATF and insta ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Crossing Traffic Alert Buzzer (w/ Rear No. 2 Seat): Installation
    INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Connect the connector. (b) Engage the clamp to install the blind spot monitor buzzer. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Click here 3. INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR Click here 4. INSTALL NO. 2 AIR COND ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0122