INSTALLATION
PROCEDURE
1. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY
(a) When reusing the telephone and GPS antenna assembly:
(1) Install a new seal.
(b) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (1) shown in the illustration to engage the guide.
| Install in this Direction (1) |
| Install in this Direction (2) |
(c) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (2) shown in the illustration to engage the 2 guides and 3 claws and install the telephone and GPS antenna assembly.
2. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER
(a) Install a new washer and holder as shown in the illustration.
| Install in this Direction |
(b) Install the telephone and GPS antenna assembly with cover with the bolt.
Torque:
9.5 N·m {97 kgf·cm, 84 in·lbf}
(c) Connect the connector
3. INSTALL ROOF HEADLINING ASSEMBLY
w/o Rear No. 2 Seat:
Click here
w/ Rear No. 2 Seat:
Click here
Removal
Telephone And Gps Antenna Cords(w/ Rear No.2 Seat)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Refrigerant Line: Removal
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Click here 2. REMOVE PIPING CLAMP (a) for Low Pressure: (1) While pressing the end of the suction hose sub-assembly into the end of the No. 2 air conditioner tube and accessory assembly, use pliers to squeeze together both sides of ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Operation Check
OPERATION CHECK HINT: The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector. BLIND SPOT MONITOR BEAM AXIS CONFIRMATION (a) When performing the blind spot monitor beam axis confirmati ...