DESCRIPTION
This DTC is stored when a malfunction occurs in the Navigation ECU.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
B1556 | Extension Module Malfunction 2 | When any of the following conditions is met:
| Navigation ECU |
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
OK | USE SIMULATION METHOD TO CHECK |
NG | REPLACE NAVIGATION ECU |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Smart Access System With Push-button Start (for Start Function): Power Source Mode does not Change to ON (IG)
DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data List and Active Test Po ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Drive Shaft Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Remov ...