DESCRIPTION
This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.
HINT:
The certification ECU (smart key ECU assembly) controls the smart access system with push-button start (for Entry Function) related items that are customizable via the multi-display assembly screen.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing malfunction |
|
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
OK:
CAN communication DTCs are not output.
NG | GO TO CAN COMMUNICATION SYSTEM |
|
2. | CHECK SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function) |
(a) Check if the smart access system with push-button start (for Entry Function) is malfunctioning.
Click here
HINT:
Customization may not be possible depending on the malfunction in the smart access system with push-button start (for Entry Function).
OK:
No malfunctions are present in the smart access system with push-button start (for Entry Function).
NG | GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function) |
|
3. | CLEAR DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
|
4. | CHECK FOR DTC |
(a) Recheck for DTCs.
Body Electrical > Navigation System > Trouble Codes Result | Proceed to |
---|---|
DTCs are not output | A |
DTCs are output | B |
A | END |
B | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Shift Paddle Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 SWITCH WIRE HINT: Perform this procedure only when replacement of the No. 1 switch wire is necessary. (a) Engage the 6 clamps to install the No. 1 switch wire to the steering wheel assembly. (b) Engage the 2 guides. (c) Connect the steering vibration and heate ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Meter / Gauge System: Speed Signal Circuit
DESCRIPTION The combination meter assembly receives the vehicle speed signal from this circuit. The wheel speed sensors produce an output that varies according to the vehicle speed. The wheel speed sensor output is received by the brake actuator assembly (skid control ECU) which uses this informatio ...