CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
| 1. | CHECK COVERAGE AREA |
(a) Check that the current position of the vehicle is within the HD weather and traffic or DCM communication function coverage area.
OK:
Vehicle is within coverage area.
| NG | | MOVE TO WITHIN COVERAGE AREA |
|
| 2. | CHECK SYMPTOMS |
(a) Check for symptoms (poor sound quality, sounds cannot be heard, etc.) during conventional FM radio broadcasting.
| Result | Proceed to |
|---|---|
| Symptoms occur | A |
| Symptoms do not occur | B |
| A | | GO TO "RADIO BROADCAST CANNOT BE RECEIVED OR POOR RECEPTION" IN PROBLEM SYMPTOMS TABLE |
|
| 3. | CHECK SYMPTOMS |
(a) Check for symptoms (Unable to connect to call center, etc.) with an ordinary safety connect.
| Result | Proceed to |
|---|---|
| Symptoms occur | A |
| Symptoms do not occur | B |
| A | | GO TO "UNABLE TO CONNECT TO CALL CENTER" IN PROBLEM SYMPTOMS TABLE |
| B | | REPLACE RADIO RECEIVER ASSEMBLY |
Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
Noise OccursLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Park Assist / Monitoring: Clearance Warning Buzzer (for Front Side)
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 CLEARANCE WARNING BUZZER - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 1 clear ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Electric Parking Brake System: Supply Voltage Circuit IG Open (C123A14)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note C123A14 Supply Voltage Circuit IG Open
Diagnosis Condition:
Engine switch on (IG)
Malfunction Status:
When the ECM is communicating via CAN communication, IG power is not input to the skid c ...