CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK PANEL SWITCH |
(a) Check for foreign matter around the switches that might prevent operation.
OK:
No foreign matter is found.
NG | ![]() | REMOVE ANY FOREIGN MATTER FOUND |
|
2. | CHECK PANEL & STEERING SWITCH (OPERATION CHECK) |
(a) Enter the "Panel & Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check. Click here |
|
(b) Operate the abnormal switch and check if the switch status is correctly displayed.
OK:
The switch status is correctly displayed as operated.
OK | ![]() | REPLACE RADIO RECEIVER ASSEMBLY |
NG | ![]() | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Fuel Pump Ecu(w/o Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY (a) Install the fuel pump control ECU assembly to the vehicle body and return the deck trim side panel assembly LH to its original position. (b) Install the 2 nuts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (c) Install the clip. (d) C ...
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Rear Seat Assembly (for 60/40 Split Seat Type Rh Side): Inspection
INSPECTION PROCEDURE 1. PRECAUTION NOTICE: After performing the following check, initialize the fold seat control ECU (initial position reset and initial position memorization). Click here 2. INSPECT REAR SEATBACK FRAME SUB-ASSEMBLY RH (a) Check the operation of the reclining motor. (1) Apply batt ...