CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
| 1. | CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
| NG | | REMOVE FOREIGN MATTER |
|
| 2. | CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
| NG | | CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
| 3. | CHECK TOUCH SWITCH (OPERATION CHECK) |
| (a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check. Click here |
|
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
| OK | | REPLACE MULTI-DISPLAY ASSEMBLY |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Panel Switches do not Function
Poor Sound Quality in All Modes (Low Volume)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Power Seat Control System (w/ Memory): Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Angle Sensor: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly. PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY Click here 2. INSTALL STEERING SENSOR (a) Align the ...