PROCEDURE
| 1. | CHECK CONDITION |
| (a) Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by a turntable. HINT: If the vehicle is turned on a turntable with the engine switch on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the engine switch off and back to on (IG) again with the vehicle completely stopped. |
|
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | TURN ENGINE SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED |
Poor Sound Quality in All Modes (Low Volume)
"No GPS signal" mark is displayedLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Throttle/Pedal Position Sensor/Switch "D" Circuit Short to Battery (P212012,P212014,P21201F,P212512,P212514,P21251F,P21382B)
DESCRIPTION HINT:
This Electronic Throttle Control System (ETCS) does not use a throttle cable.
These DTCs relate to the accelerator pedal position sensor.
The accelerator pedal position sensor is built into the accelerator pedal sensor assembly and has 2 sensor circuits: VPA (main) and VPA2 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Position Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during camshaft position sensor removal/installation are shown below. Necessary Procedures After Parts Removed/ ...