WIRING DIAGRAM
PROCEDURE
| 1. | CHECK VOICE GUIDANCE SETTING |
(a) Check that the voice guidance settings are not off.
OK:
Voice guidance settings are not off.
| NG | | CHANGE VOICE GUIDANCE SETTINGS TO ON |
|
| 2. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) |
(a) Disconnect the J149 radio receiver assembly connector.
(b) Disconnect the J153 navigation ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J149-22 (SI+) - J153-6 (VOI+) | Always | Below 1 Ω |
| J149-23 (SI-) - J153-7 (VOI-) | Always | Below 1 Ω |
| J149-22 (SI+) or J153-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| J149-23 (SI-) or J153-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| J153-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
"No GPS signal" mark is displayed
Voice is not RecognizedLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Hazard Warning Switch: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hazard warning switch (radio receiver assembly)removal/installation are shown below. Necessary Procedure ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Electrical Key Oscillator (for Outside Luggage Compartment): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electrical key removal/installation are shown below. Necessary Procedures After Parts Removed/Installed ...