Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electrical key removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

*1: When performing learning using the Techstream.

Click here

Disconnect cable from negative (-) battery terminal

Memorize steering angle neutral point

Lane Control System

Pre-collision System

Intelligent Clearance Sonar System*1

Parking Assist Monitor System

Panoramic View Monitor System

Lighting System (w/ Automatic Headlight Beam Level Control System)

Initialize back door lock

Power Door Lock Control System

Reset back door close position

Power Back Door System (w/ Outside Door Control Switch)

Rear bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent clearance sonar system
  • Intuitive parking assist system

PROCEDURE

1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear No. 2 Seat)

Click here

2. REMOVE REAR BUMPER ASSEMBLY (w/ Rear No. 2 Seat)

Click here

3. REMOVE REAR BUMPER ENERGY ABSORBER (w/o Rear No. 2 Seat)

Click here

4. REMOVE REAR BUMPER ENERGY ABSORBER (w/ Rear No. 2 Seat)

Click here

5. REMOVE ELECTRICAL KEY ANTENNA

(a) Disconnect the connector.

Remove in this Direction

(b) Remove the nut.

(c) Disengage the guide to remove the electrical key antenna as shown in the illustration.

NOTICE:

Be careful when removing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.

    Components
    COMPONENTS ILLUSTRATION *A w/o Rear No. 2 Seat *B w/ Rear No. 2 Seat *1 ELECTRICAL KEY ANTENNA *2 REAR BUMPER ENERGY ABSORBER ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL ELECTRICAL KEY ANTENNA (a) Engage the guide as shown in the illustration and install the electrical key antenna with the nut. Install in this Direction NOTI ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Emission Control System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 CANISTER (CHARCOAL CANISTER ASSEMBLY) *2 FUEL TANK CAP ASSEMBLY *3 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) *4 PURGE VALVE (PURGE VSV) *5 ECM *6 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY - EFI MAIN RELAY - EFI-MAIN ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Radio Antenna Cord (w/o Rear No. 2 Seat): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0088