REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone microphone assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
w/o Rear No. 2 Seat:
Click here
w/ Rear No. 2 Seat:
Click here
2. REMOVE TELEPHONE MICROPHONE ASSEMBLY
(a) Disconnect the connector.
| *1 | Telephone Microphone Assembly |
| *2 | No. 1 Microphone Case |
| Remove in this Direction (Telephone Microphone Assembly) |
| Remove in this Direction (No. 1 Microphone Case) |
(b) Disengage the 2 claws and remove the telephone microphone assembly from the No. 1 microphone case.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/o Memory): System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Air Conditioning Amplifier Assembly Main Body ECU (Multiplex Network Body ECU) Mirror heater drive request signal CAN Main Body ECU (Multiplex Network Body ECU) Outer Mirror Control ECU Assembly
IG sign ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Angle Sensor: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly. PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY Click here 2. INSTALL STEERING SENSOR (a) Align the ...