Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Installation

NOTICE:

• Avoid any impact to the blind spot monitor sensor.
• Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

HINT:

• The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.
• The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector.
• The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-4°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during bli ...

Blind Spot Monitor System

...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Heated Steering Wheel Controller: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING VIBRATION AND HEATER ECU (a) Connect the connector to the steering vibration and heater ECU. (b) Install the steering vibration and heater ECU to the lower steering wheel boss cover with the 2 screws. NOTICE: If the heater thermistor comes off the lower ste ...

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): PBD Unit Pulse Sensor RH Circuit (B2227)
DESCRIPTION This DTC is stored when the multiplex network door ECU detects an error in the power back door unit assembly set RH pulse signal. DTC No. Detection Item DTC Detection Condition Trouble Area B2227 PBD Unit Pulse Sensor RH Circuit Multiplex network door ECU detects power b ...