CUSTOMIZE PARAMETERS
CUSTOMIZE BLIND SPOT MONITOR SYSTEM
(a) Customizing with the Techstream
NOTICE:
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the blind spot monitor system on.
(4) Turn the Techstream on.
(5) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.
(6) Select the setting by referring to the table below.
Warning Tester Display | Description | Default | Setting | ECU |
---|---|---|---|---|
BSM Buzzer Volume Adjust | Sets the volume of the RCTA buzzer (blind spot monitor buzzer). | Medium | 001:Low,011:Medium,101:High | Blind Spot Monitor Sensor LH |
BSM Mirror Indicator Brightness | Sets the brightness of the indicators in the outer rear view mirror assemblies. | Bright | 001:Dark,101:Bright | Blind Spot Monitor Sensor LH |
RCTA Function | Switches the RCTA function on and off.* | ON | 0:ON,1:OFF | Blind Spot Monitor Sensor RH |
BSM Approaching Vehicle Detection Timing Setting | Sets the notification timing for vehicles approaching from behind the vehicle. | Middle | 00:Only Blind Spot,01:Late,10:Middle,11:Early | Blind Spot Monitor Sensor LH |
(b) Customizing with multi-display
NOTICE:
(1) Turn the engine switch on (IG).
(2) Turn the blind spot monitor system on.
(3) Enter the following menus: MENU / Setup / Vehicle / Blind Spot Monitor Setting.
(4) Select the setting by referring to the table below.
Blind Spot Monitor Setting Display | Description | Default | Setting | ECU |
---|---|---|---|---|
Outside Rear View Monitor Indicator Brightness | Sets the brightness of the indicators in the outer rear view mirror assemblies. | Bright | Dark or Bright | Blind Spot Monitor Sensor LH |
Rear Cross Traffic Alert Volume | Sets the volume of the RCTA buzzer (blind spot monitor buzzer). | 2 | 3 , 2 or 1 | Blind Spot Monitor Sensor LH |
BSM Approaching Vehicle Detection Timing | Sets the notification timing for vehicles approaching from behind the vehicle. | Middle | Early, Middle, Late or Only Blind Spot | Blind Spot Monitor Sensor LH |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Panoramic View Monitor System: Image from Camera for Panoramic View Monitor is Abnormal
DESCRIPTION The display signal from the rear television camera assembly is transmitted to the multi-display assembly via the parking assist ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative ( ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Lighting (ext): Front Side Marker Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. DISCONNECT FRONT FENDER MOULDING SUB-ASSEMBLY (for TMMC Made) Click here 2. REMOVE FRONT SIDE MARKER LIGHT BULB (a) except TM ...