DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for vehicle stability control system DTCs.
Click here
OK:
Vehicle stability control system DTCs are not output.
| NG | | GO TO VEHICLE STABILITY CONTROL SYSTEM |
|
| 2. | CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A45 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A45 is output ("Blind Spot Monitor Slave"). | C |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE BLIND SPOT MONITOR SENSOR LH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR RH |
Data List / Active Test
Yaw Rate Sensor (C1A46)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Electric Parking Brake System: Test Mode Procedure
TEST MODE PROCEDURE REAR BRAKE PAD REPLACEMENT MODE *1 Rear Disc Brake Piston *2 Nut *a The nut moves inward in pad replacement mode HINT: When replacing the rear disc brake pad and rear disc, since the nut inside the rear disc brake cylinder assembly is in an advanced position, ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting (ext): License Plate Light Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 LICENSE PLATE LIGHT ASSEMBLY - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY Click her ...