DESCRIPTION
The blind spot monitor sensor receives yaw rate signals from the yaw rate and acceleration sensor via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A46 | Yaw Rate Sensor | A fail flag is transmitted from the yaw rate and acceleration sensor |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for vehicle stability control system DTCs.
Click here
OK:
Vehicle stability control system DTCs are not output.
| NG | | GO TO VEHICLE STABILITY CONTROL SYSTEM |
|
| 2. | RECHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A46 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A46 is output ("Blind Spot Monitor Slave"). | C |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE BLIND SPOT MONITOR SENSOR LH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR RH |
Vehicle Speed Sensor (C1A45)
Steering Angle Sensor (C1A47)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lexus Enform System: System Description
SYSTEM DESCRIPTION DESCRIPTION
LEXUS ENFORM allows the vehicle to receive information from the call center and links the information to the navigation system. LEXUS ENFORM permits the driver to use the received information, such as destination information, on the navigation system.
LEXUS ENFORM ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Conditioning Amplifier: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air conditioning amplifier removal/installation are shown below. Necessary Procedure After Parts Remove ...