DESCRIPTION
The blind spot monitor sensor receives steering angle signals from the steering angle sensor via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A47 | Steering Angle Sensor | A fail flag is transmitted from the steering angle sensor |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
No DTCs are output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE STEERING SENSOR |
(a) Replace the steering sensor.
Click here
|
| 3. | RECHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A47 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A47 is output ("Blind Spot Monitor Slave"). | C |
| A | | END |
| B | | REPLACE BLIND SPOT MONITOR SENSOR LH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR RH |
Yaw Rate Sensor (C1A46)
Short to +B in Outer Mirror Indicator(Master) (C1AB0)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Seatback Heater: Components
COMPONENTS ILLUSTRATION *A for Standard Seat Type *B for Sports Seat Type *1 FRONT SEAT CUSHION SHIELD *2 FRONT SEAT INNER CUSHION SHIELD *3 INNER NO. 1 FRONT SEAT CUSHION SHIELD - - ILLUSTRATION *1 SEPARATE TYPE FRONT SEATBACK ASSEMBLY *2 SEPARATE TYPE FRO ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lane Control System: Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (LANE CONTROL SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn t ...