INSTALLATION
PROCEDURE
1. INSTALL NO. 2 CLEARANCE WARNING BUZZER
(a) Connect the connector.
(b) Engage the clamp to install the No. 2 clearance warning buzzer.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
4. INSTALL ROPE HOOK ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
6. INSTALL REAR SEAT SIDE GARNISH RH
Click here
7. INSTALL FRONT DECK SIDE TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
Click here
8. INSTALL REAR SEAT OUTER TRACK BRACKET COVER RH
for 60/40 Split Seat Type:
Click here
for Captain Seat Type:
HINT:
Use the same procedure as for the LH side.
Click here
9. INSTALL REAR DOOR INSIDE SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
10. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
11. INSTALL REAR NO. 2 SEAT ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Smart Access System With Push-button Start (for Start Function): Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under man ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vehicle Stability Control System: Steering Angle Sensor Supply Voltage Circuit Circuit Short to Ground or Open (C14FE14)
DESCRIPTION This DTC is stored when the skid control ECU (brake actuator assembly) receives a power supply malfunction signal from the steering angle sensor. DTC No. Detection Item DTC Detection Condition Trouble Area C14FE14 Steering Angle Sensor Supply Voltage Circuit Circuit Short ...