PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Lane Control System | |
| Pre-collision System | |
| Intelligent Clearance Sonar System | |
| Parking Assist Monitor System | |
| Panoramic View Monitor System | |
| Lighting System (w/ Automatic Headlight Beam Level Control System) | |
| Power Door Lock Control System | |
| Power Back Door System (w/ Outside Door Control Switch) |
PRECAUTIONS FOR INTUITIVE PARKING ASSIST SYSTEM
(a) Under the following conditions, the detection function may not function properly:
(1) A sensor is covered with foreign matter, such as mud or snow (detection function returns to normal when the sensor is cleaned).
(2) A sensor is frozen (detection function returns to normal when the temperature of the sensor rises).
(3) A hand is blocking a sensor.
HINT:
(b) The detection range may be affected by the following conditions:
(1) A sensor is covered with foreign matter, such as mud or snow.
(2) The vehicle is in an excessively hot or excessively cold area.
(c) Under the following conditions, a detection error may occur:
(1) Driving on a bumpy road, an unpaved road or in tall grass.
(2) Ultrasonic waves are received from the horn or parking sonar system of another vehicle, a motorcycle engine, or the air brakes of a large vehicle.
(3) It is raining heavily or the sensor is sprayed with water.
(4) The vehicle is tilted at a steep angle.
(5) The vehicle is equipped with a fender pole or a wireless antenna mechanism.
(6) A sensor is covered with foreign matter, such as mud or snow.
(7) The vehicle is moving forward or backward towards high curbs or objects that are perpendicular to the ground.
(8) A sensor is sprayed with high pressure water or steam.
(9) A towing hitch is mounted on the vehicle.
(d) The sensors cannot detect the following objects:
(1) Thin objects, such as wires and ropes
(2) Materials that absorb ultrasonic waves, such as cotton or snow.
(3) Objects with sharp edges
(4) Short objects
(5) Objects that are tall and protrude toward the vehicle above the detection range of the sensors.
(e) Other notices:
(1) The sensors cannot detect objects directly under the bumper. (A sensor may detect low objects and thin poles, and then lose track of them.)
(2) Be aware that the detection range of this system is limited. In certain conditions, some objects may not be detected. Always make sure to check all around the vehicle when driving or parking.
(3) The sensors may not be able to detect obstacles that are too close to the sensors.
(4) The sensors may not be able to detect obstacles if the sensors have been dropped or subjected to a strong impact.
Parts LocationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Camera: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Re ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Clearance Warning ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Clearance Warning ECU Communication Stop Mode Either condition is met:
"Clearance Warning (Intuitive Parking Assist)" is not displayed on the CAN Bus Check screen of the Techstream.
Click here
Communication system DTCs (DTCs that ...