CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | CUSTOMER PROBLEM ANALYSIS |
|
| 3. | INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
|
| 4. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
| B | | GO TO CAN COMMUNICATION SYSTEM |
|
| 5. | PROBLEM SYMPTOM CONFIRMATION |
|
| 6. | CHECK DTC* |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output (Problem symptom does not occur) | B |
| DTCs are not output (Problem symptom occurs) | C |
| B | | GO TO STEP 8 |
| C | | GO TO STEP 9 |
|
| 7. | DIAGNOSTIC TROUBLE CODE CHART (INTELLIGENT CLEARANCE SONAR SYSTEM) |
(a) Refer to Diagnostic Trouble Code Chart.
Click here
NOTICE:
The clearance warning ECU assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the intelligent clearance sonar system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
| System | Proceed to |
|---|---|
| Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System) | |
| NEXT | | GO TO STEP 11 |
| 8. | SYMPTOM SIMULATION |
(a) Refer to Symptom Simulation.
Click here
|
| 9. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
| B | | GO TO STEP 11 |
|
| 10. | OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Operation Check
Click here
(b) Terminals of ECU
Click here
(c) Data List / Active Test
Click here
|
| 11. | CIRCUIT INSPECTION |
|
| 12. | IDENTIFICATION OF PROBLEM |
|
| 13. | REPAIR OR REPLACE |
|
| 14. | CONFIRMATION TEST |
| NEXT | | END |
System Diagram
Operation CheckLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Oil Pump: Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER ASSEMBLY (a) Clean the contact surfaces of the engine assembly, and confirm that no oil, moisture, or other foreign matter is on the surfaces. *a Engine Assembly Side *b Timing Chain Cover Assembly Side Clean - - NOTICE: Be ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Headlight Swivel ECU LH Communication (B2410,B2411)
DESCRIPTION Each No. 1 headlight ECU sub-assembly and headlight swivel motor communicate via LIN communication. The headlight swivel motor operates according to power supplied and automatic headlight beam level control signals from its respective No. 1 headlight ECU sub-assembly and sends its operat ...