DESCRIPTION
When it is judged that the front sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF3.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AF3 | Fr Sensor Initialization Incomplete | Front sensor not initialized |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | INITIALIZE FRONT CENTER ULTRASONIC SENSOR AND FRONT CORNER ULTRASONIC SENSOR |
(a) Initialize the front center ultrasonic sensor and front corner ultrasonic sensor.
Click here
|
| 2. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
Click here
HINT:
After turning the engine switch from off to on (IG), wait 10 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1AF3 is output | A |
| DTC C1AF3 is not output | B |
HINT:
If DTC C1AF3 is still output after initializing the front center ultrasonic sensor and front corner ultrasonic sensor 3 times, replace the clearance warning ECU assembly.
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (FRONT SENSORS WERE NOT INITIALIZED) |
ICS Detection Area Adjustment Incomplete (C1AF0)
Rr Sensor Initialization Incomplete (C1AF4)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 2 Seat Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame may injure your hands. PROCEDURE 1. INSTALL REAR SEAT INNER BELT COVER LH (a) Engage the claw. (b) Install the rear seat inner belt cover LH with the clip. 2. INSTALL REAR ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Brake System Control Module "A" Internal Electronic Failure (C059749,...,C13C91C)
DESCRIPTION The solenoid relay and solenoid valves are built into the brake actuator assembly. The solenoid valves control the brake fluid pressure at each wheel cylinder. When this DTC is stored, the fail-safe function operates and the solenoid relay is turned off to prevent the solenoid valves fro ...