CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | CUSTOMER PROBLEM ANALYSIS |
|
| 3. | INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
|
| 4. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
| B | | GO TO CAN COMMUNICATION SYSTEM |
|
| 5. | PROBLEM SYMPTOM CONFIRMATION |
|
| 6. | CHECK DTC* |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output (Problem symptom does not occur) | B |
| DTCs are not output (Problem symptom occurs) | C |
| B | | GO TO STEP 8 |
| C | | GO TO STEP 9 |
|
| 7. | DIAGNOSTIC TROUBLE CODE CHART (INTUITIVE PARKING ASSIST SYSTEM) |
(a) Refer to Diagnostic Trouble Code Chart.
Click here
NOTICE:
The clearance warning ECU assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the intuitive parking assist system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
| System | Proceed to |
|---|---|
| Intelligent Clearance Sonar System | |
| NEXT | | GO TO STEP 11 |
| 8. | SYMPTOM SIMULATION |
(a) Refer to Symptom Simulation.
Click here
|
| 9. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
| B | | GO TO STEP 11 |
|
| 10. | OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Operation Check
Click here
(b) Terminals of ECU
Click here
(c) Data List / Active Test
Click here
|
| 11. | CIRCUIT INSPECTION |
|
| 12. | IDENTIFICATION OF PROBLEM |
|
| 13. | REPAIR OR REPLACE |
|
| 14. | CONFIRMATION TEST |
| NEXT | | END |
System Diagram
Operation CheckLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ambient Light (for Instrument Panel): Inspection
INSPECTION PROCEDURE 1. INSPECT INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY (INSTRUMENT PANEL AMBIENT ILLUMINATION LIGHT) (a) Apply battery voltage to the connector and check that the instrument panel ambient illumination light comes on. OK: Measurement Condition Condition Specified Conditio ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SHIFT SOLENOID VALVE SLT (a) Coat the shift solenoid valve SLT with ATF and install it to the transmission valve body assembly. (b) Install the straight pin. 2. INSTALL SHIFT SOLENOID VALVE SL5 (a) Coat the shift solenoid valve SL5 with ATF and insta ...