DESCRIPTION
The front center ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sensor RH. If the front center ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
---|---|---|---|
C1AE3 | Front Right Center Sensor | A malfunction of the front center ultrasonic sensor RH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here
PROCEDURE
1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
Result | Proceed to |
---|---|
Only DTC C1AE3 is output | A |
DTC C1AE3 and C1AEC are output | B |
No DTCs are output | C |
B | ![]() | GO TO DTC (C1AEC) |
C | ![]() | USE SIMULATION METHOD TO CHECK |
|
2. | REPLACE FRONT CENTER ULTRASONIC SENSOR RH |
(a) Replace the front center ultrasonic sensor RH with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
Result | Proceed to |
---|---|
DTC C1AE3 is output | A |
No DTCs are output | B |
A | ![]() | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
B | ![]() | END (FRONT RIGHT CENTER SENSOR WAS DEFECTIVE) |
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Disc cannot be Inserted or is Ejected Right After Insertion
CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System. Click here PROCEDURE 1. CHECK IF A PROPER DISC IS INSERTED ...
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Blind Spot Monitor System: Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to ground in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB3 Short to GND in Outer Mirror Indicator(Slave) Both of the following condition ...