DESCRIPTION
The front center ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultrasonic sensor LH. If the front center ultrasonic sensor LH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE2 | Front Left Center Sensor | A malfunction of the front center ultrasonic sensor LH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the engine switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| Only DTC C1AE2 is output | A |
| DTC C1AE2 and C1AEC are output | B |
| No DTCs are output | C |
| B | | GO TO DTC (C1AEC) |
| C | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE FRONT CENTER ULTRASONIC SENSOR LH |
(a) Replace the front center ultrasonic sensor LH with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC C1AE2 is output | A |
| No DTCs are output | B |
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (FRONT LEFT CENTER SENSOR WAS DEFECTIVE) |
Front Left Sensor Malfunction (C1AE1)
Front Right Center Sensor (C1AE3)Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Do-it-yourself
maintenance: Tire inflation pressure
Tire inflation pressure
The recommended cold tire inflation
pressure and tire size are displayed on
the tire and loading information label.
Inspection and adjustment procedure
Tire valve
Tire pressure gauge
1. Remove the tire valve cap.
2. Press the tip of the tire pressure gauge o ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Gear: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING RACK BOOT CLIP (for LH Side) (a) Using pliers, remove the steering rack boot clip. 2. REMOVE STEERING RACK BOOT CLIP (for RH Side) HINT: Perform the same procedure as for the LH side. 3. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side) (a) Using a screw ...