REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL GARNISH LH
Click here
2. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
3. REMOVE COWL SIDE TRIM BOARD LH
Click here
4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
7. REMOVE PANORAMIC VIEW MONITOR SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
| (a) Disengage the 4 claws and remove the panoramic view monitor switch (integration control and panel assembly). |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Dynamic radar cruise
control with full-speed
range: Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles up to
approximately 328 ft. (100 m) ahead, determines the current vehicle-to-vehicle
following distance, and operates to maintain a suitable following distance from
the vehicle ahead.
Note that vehicle-to-vehicle distance will ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Clearance Warning Buzzer (for Rear Side Without Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CLEARANCE WARNING BUZZER (a) Connect the connector. (b) Engage the clamp to install the No. 2 clearance warning buzzer. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Click here 3. INSTALL RECLINING REMOTE CONTROL BEZEL RH (w/o Rear Power Seat System) Click her ...