DESCRIPTION
DTC C1621 is stored if the parking assist ECU determines that the input/output signal communication with the rear television camera assembly is abnormal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1621 | Back Camera Current Malfunction | Rear television camera assembly power supply malfunction |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY) |
(a) Disconnect the J158 parking assist ECU connector.
(b) Disconnect the Z11 rear television camera assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J158-33 (CB+) - Z11-6 (CB+) | Always | Below 1 Ω |
| J158-32 (CGND) - Z11-5 (CGND) | Always | Below 1 Ω |
| J158-33 (CB+) or Z11-6 (CB+) - Body ground | Always | 10 kΩ or higher |
| J158-32 (CGND) or Z11-5 (CGND) - Body ground | Always | 10 kΩ or higher |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
| 2. | CHECK PARKING ASSIST ECU (CB+, CGND) |
| (a) Connect the J158 parking assist ECU connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J158-32 (CGND) - Body ground | Always | Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J158-33 (CB+) - J158-32 (CGND) | Engine switch on (IG) | 5.5 to 7.05 V |
| OK | | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
| NG | | REPLACE PARKING ASSIST ECU |
ECU Malfunction (C1614)
Back Camera Feedback Malfunction (C1622)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Exhaust Manifold: Installation
INSTALLATION PROCEDURE 1. INSTALL STUD BOLT HINT: If a stud bolt is deformed or its threads are damaged, replace it. (a) Using an E8 "TORX" socket wrench, install the 2 stud bolts to the exhaust manifold (TWC: Front Catalyst). Torque: 19.5 N·m {199 kgf·cm, 14 ft·lbf} (b) Using ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Tilt And Power Telescopic Steering Column System: IG Power Source Circuit
DESCRIPTION When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also receives engine switch signals via this circuit. WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Inspect ...