Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Camera Position Adjustment Incomplete (C1697)

NOTICE:

• When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

  Click here

• Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

  Click here

HINT:

• If DTC C1697 is output, perform the camera view adjustment again.
• If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.

Steering Angle Initialization Incomplete (C1694)

DESCRIPTION This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete). DTC No. Detection Item DTC Detec ...

Front Camera Internal Circuit (C2A60)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the front television camera assembly via CAN communication. DTC No. Detection Item DTC De ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seatback Heater (for Captain Seat Type): Inspection
INSPECTION PROCEDURE 1. INSPECT SEAT HEATER ASSEMBLY (for LH Side) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Seat heater temperature 20 °C (68 °F) 3.98 to 4.78 Ω If the ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Generator (for 150 A Type): Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR PULLEY CAP (a) Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch. NOTICE: Do not reuse the generator pulley cap. 2. REMOVE GENERATOR PULLEY WITH CLUTCH (a) Secure the generator assembly in a vise betwee ...