INSTALLATION
PROCEDURE
1. INSTALL PARKING ASSIST ECU
(a) Install the parking assist ECU with the bolt and nut.
(b) Connect each connector.
2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
Click here
5. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
6. INSTALL INSTRUMENT PANEL GARNISH RH
Click here
7. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
9. PERFORM PANORAMIC VIEW MONITOR SYSTEM CALIBRATION
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Left Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open (C14E614,C14E914)
DESCRIPTION Refer to DTC C050C1F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C14E614 Left Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open With the +BS terminal voltage 9.5 to 17.4 V, the sensor power supply voltage decreases for 0 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Door Window Frame Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear door window frame moulding removal/installation are shown below. Necessary Procedures After Parts R ...